Shloim Posted June 21, 2014 Report Share Posted June 21, 2014 First the motor freaked out a couple of times it sort of shut down and water temp lite came on. I shut it down and then it ran fine after both times, also my power trim gave me a bit of trouble and works but no when all thecway down without a boost. With a little lift/ help getting started it works fine. Only intermittent trouble going up from the all the way down position.... Any advice? Link to comment Share on other sites More sharing options...
John Bacon Posted June 22, 2014 Report Share Posted June 22, 2014 Get the impeller for the water pump replaced. You may be able to do this yourself if you are handy. I am not sure about the power trim. Link to comment Share on other sites More sharing options...
sneak_e_pete Posted June 22, 2014 Report Share Posted June 22, 2014 Yup...change impeller and check the fluid for the trim. I would expect it is low/dirty/old Link to comment Share on other sites More sharing options...
mikeh Posted June 22, 2014 Report Share Posted June 22, 2014 is this a brand new motor? Link to comment Share on other sites More sharing options...
fishindevil Posted June 22, 2014 Report Share Posted June 22, 2014 The motor sounds like it gas overheat protection on it wich is good !!! Yes change impeller is a start DO NOT OVERHEAT THAY MOTOR OR WAY MORE SERIOUS DAMAGE CAN HAPPEN like wrapped heads go get it serviced Link to comment Share on other sites More sharing options...
aplumma Posted June 22, 2014 Report Share Posted June 22, 2014 If you are unsure of why it died/overheated and it could be the impeller it is better to have it diagnosed by a professional and repaired. The penalty of over heating can be expensive. Art Link to comment Share on other sites More sharing options...
bigbuck Posted June 22, 2014 Report Share Posted June 22, 2014 (edited) Change your impeller to start with. Check the fluid in the trim. Also, check out Iboats.com, the forums there are invaluable. You can download the Shop manual for your motor which can help to diagnose your problems. Also, you can post your issues and some of the regular contributors are oldtime marine mechanics who are incredible resources. PS. Do not run your boat again until you change the impeller. That should be done yearly on a boat that is run a lot. It is cheap insurance esp if you do it yourself. Edited June 22, 2014 by bigbuck Link to comment Share on other sites More sharing options...
Shloim Posted June 23, 2014 Author Report Share Posted June 23, 2014 Thanks for all your replies . So after being on the water all day yesterday the overheating was from weeds and it runs fine . The problem is with the trim. So it worked fine when I launched and then it crapped out mid day. We were at a friends cottage and checked it at the dock and found some burnt wires, then after pulling it out of the water and getting a better look, found a couple more burn wires... Cab anyone recommend a good mechanic close to the city if possible? I'm freaking out a bit now.... Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now