frodobuggins Posted August 7, 2015 Report Share Posted August 7, 2015 Yesterday while out on the water the trim up at the console stopped working. Trim down still worked. However, the motor has a switch on it and i could trim both ways from there. Is this a solenoid issue? If it is, is it something i can swap out on my own? Cheers Link to comment Share on other sites More sharing options...
2 tone z71 Posted August 7, 2015 Report Share Posted August 7, 2015 Sounds like the switch in the handle failed ..if it still goes up/down at the motor ...could have been a relay but not if its still functioning Link to comment Share on other sites More sharing options...
mike rousseau Posted August 7, 2015 Report Share Posted August 7, 2015 Should be the switch Same thing happened to me Changed the switch and everything was good to go Link to comment Share on other sites More sharing options...
bigbuck Posted August 7, 2015 Report Share Posted August 7, 2015 Switch. The relays and everything else works so it has to be that switch in the handle. Should not be too difficult. Link to comment Share on other sites More sharing options...
esoxansteel Posted August 7, 2015 Report Share Posted August 7, 2015 BTW just had the relays go on mine, marine relays were 40.00 each, auto motive which are the same were 7.00 each, Link to comment Share on other sites More sharing options...
ecmilley Posted August 8, 2015 Report Share Posted August 8, 2015 switch most likely but have repaired many broken wires for the same thing in the handle. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now