baironhorse Posted September 22, 2010 Report Posted September 22, 2010 May sound stupid...new to trailer game...Have a 1991 ez loader trailer...every time I launch should I disconnect lighting system to avoid shorting? Also what fuse in car panel controls trailer lights? is it same on all vehicles...currently use 02 kia to tow? thx
Raf Posted September 22, 2010 Report Posted September 22, 2010 yes disconnect them. will prevent the bulbs in the trailer from blowing out typically, trailers are wired to your rear tailights - so that fuse.
Fisherman Posted September 22, 2010 Report Posted September 22, 2010 Some vehicles do have separate fuses for the trailer circuits, mainly to protect from botched trailer wiring and, if the trailer is screwed up, it will only affect the trailer lighting and not the tow vehicle. Each vehicle is different, check your manual, you know the little booklet that provides info about your vehicle that you should read.
OhioFisherman Posted September 22, 2010 Report Posted September 22, 2010 The glass on the bulbs may be hot after a drive, contact will cold water can crack them. A lot of water proof lights aren`t really.
mercman Posted September 22, 2010 Report Posted September 22, 2010 unplug em. Some trailers us led lites and are sealed, but get used to unpluging and you wont have any problems
Carp Posted September 22, 2010 Report Posted September 22, 2010 We always had problems with corrosion and burnt out lights despite unplugging them. Then I bought a set of magnetic tow lights and I just remove them before launching. Store them in a box in my vehicle. They never see water, unless you're driving in the rain or snow/slush. The magnets are fairly strong, but can pop off if going over potholes, railway tracks, bumps, etc. I go the extra step and put plastic fasteners (ties) in a criss cross pattern around the lights to ensure they don't fall off. Snip them off while launching (discard in trash bin) and re-apply new ones before leaving the launch area. Seems time consuming at first, but as you do it more often, it shouldn't take more than 1 min. to remove them and about 3 or 4 min. to set up again. You can buy plastic ties in bulk packages for just a few dollars. If you need more length than you have , 2 or more can be fastened together. A few pieces of heavy gauge wire (insulated) could be used as well and can easily be re-used many times. Hope this helps.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now