Jump to content

Old Outboard Motor Help


sneak_e_pete

Recommended Posts

Hi all, I am hoping that you can offer me some tips. I have a 12 ft. aluminum and have never used an outboard on it because the lake I fish is electric only. My wife's uncle has given me a 1956 (I think that is the year) Viking 6hp. It is in very good shape and is very clean, but it has sat stored and unused for almost 20 years. Before he gave it to me, he pulled it out and it started right up with a shot of fluid in the carburator though so that was exciting.

 

Sooo...long story short, my question is, other than changing the lower unit oil and spark plug, is there anything I should do to make it run better/safer before I use it on open water for the first time. I must admit that I'm a little nervous of it because it is so old. Any advice is greatly appreciated.

 

Thanks.

Link to comment
Share on other sites

Your Viking is probably a Chrysler underneath the hood. My Dad had some good luck with Vikings.

 

Lower unit oil is a must, and plugs. Other than that, check the rubber components (like spark plug wires) for cracks. Use some black electrical tape, or heat-shrink tubing, where you see signs of wear.

 

Grease or oil any joints and moving parts that are visible. Some can be sprayed with LPS 1 (my wonder cure and problem preventer for a lot of stuff - much better than WD-40).

 

After you have had the motor in operation for a few hours, drain and refill the lower unit oil again. If there's any water in the oil, you might have to change the seals, or at least drain and refill a few times per season. Depends on how much you use the motor, I guess.

 

6 HP is a nice little kicker for a 12-footer. And old motors are much more fun than new ones! Good luck with it.

Edited by Jocko Point Jonny
Link to comment
Share on other sites

Change the water pump impeller before you take it out on the water. It will have taken a set will be badlt deteriorated and will disintegrate as soon as it is used. You don't want the little bits of rubber to clog any of the water passages.

 

Change the plugs and do a carb rebuild, also replace any fuel lines and filter.

Link to comment
Share on other sites

Thanks for the advice. Any idea where I would get those parts?

 

Try some internet searches.

 

Here's one that came up when I typed in "viking outboard parts canada". Looks like you can get some help with Viking/Chrysler if you follow up the email addy...

 

http://www.mapleleafchapter.org/parts.html

 

BTW, it seems your motor could be newer than you think? ......... Looks like a 6 HP model wasn't made til 1968... according to this source anyway...

 

http://www.discount-marine-parts.com/ob_viking_model.html

Edited by Jocko Point Jonny
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recent Topics

    Popular Topics

    Upcoming Events

    No upcoming events found

×
×
  • Create New...