ecmilley Posted February 6, 2013 Report Posted February 6, 2013 my 8 inch fin bore isn't cuttiing very good so i bought some new blades and it isn't any better, been told to shim it to get it to cut properly again, anyone know what angles to shoot for or is it a matter of trail and error? this would be reason #1 not to lend out an auger banging it on the ice to clear it is a no no
EC1 Posted February 6, 2013 Report Posted February 6, 2013 I found that when I replaced the blades, the auger goes back to normal, so I'm no help here. If I was to lend my auger again, I'm gonna get the guy to drill me a hole right next to me so I know they know how to use it before I lend it to them. Sucks when your auger is destroyed before the end of the day and you can't move anymore.
Jet Posted February 6, 2013 Report Posted February 6, 2013 (edited) Definitely sounds like something is bent out of angle as you shouldn't have to shim the blades at all. Perhaps you can compare your auger to a good one and see where it might be bent and try adjusting it from there. Edited February 7, 2013 by Jet
barrystrs Posted February 6, 2013 Report Posted February 6, 2013 If anyone figures out what angle they should be at, I would like to know also. I tried shimming, no luck.
Rod Caster Posted February 7, 2013 Report Posted February 7, 2013 Like Jet said, sounds like something is bent. The new blades should cut like new, with no maintenance required.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now