Doctrt Posted January 18, 2010 Report Share Posted January 18, 2010 Just ran my new Strikemaster Magnum up at the bog. Two holes, no problem. Shut er down for a few minutes and decided I wanted the holes a little closer together. When I went to start it up again, the pull cord had no resistance. I pressed the decomp button on every pull and everything seemed fine, but now it seems that the pull cord isn't engaging the rest of the motor. Any ideas?? Help Please!! BTW fishing was slow other than a few good sized Crappies. Thanks in advance. T Link to comment Share on other sites More sharing options...
vinnimon Posted January 18, 2010 Report Share Posted January 18, 2010 Pull the cover and spool off and you should find your problem.If its the same as a lazer magX there are 3 screws on the top.Did you try pulling the cord under comp and had a lot of resistance? Link to comment Share on other sites More sharing options...
Doctrt Posted January 18, 2010 Author Report Share Posted January 18, 2010 Thanks for the help Vin. I did what you said and you were right, it was pretty obvious what my problem was, a small plastic piece on the back of the cord wheel was ripped to shreds. I assume this is what engages the fly-wheel, but I'm not sure why it was damaged. Nonetheless, does anyone know where or how I can get a replacement part for this Strikemaster Auger? Or better yet, does anyone know how to avoid this problem in the future? Thanks again. T Link to comment Share on other sites More sharing options...
Pguzik Posted January 18, 2010 Report Share Posted January 18, 2010 (edited) You need to call authorized mechanic for strike master on the web site and they will order you a starter assembly for $65 taxes in. one located in Mississauga near lake shore IN the mean time go to www.strikemaster.com and watch the video on how to properly start the auger. My buddy yanked on it a little tooooo hard and it was toast. Its just a small plastic piece (red) that brakes, but you need to whole assembly. If you know any one in the states you can order directly from SOLO USA and it will cost $24.50 hope this helps Edited January 18, 2010 by Wildstlhead Link to comment Share on other sites More sharing options...
Bernie Posted January 18, 2010 Report Share Posted January 18, 2010 Just a note to add. Many times I see someone yank the cord on a rewind and not take up the slack first. Gently pull the cord until the starter pawl engages the flywheel, then pull the cord to start. This prevents a lot of wear and tear on all the rewind parts. Link to comment Share on other sites More sharing options...
redneck666 Posted January 18, 2010 Report Share Posted January 18, 2010 ya, bernie is right again. i watched my buddy snapped his pull cord on his sled the other day when he didnt take up any slack and yanked pretty hard. Link to comment Share on other sites More sharing options...
Garnet Posted January 18, 2010 Report Share Posted January 18, 2010 Bay Distributors North Bay will have the parts you need. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now