addy79 Posted November 1, 2007 Report Posted November 1, 2007 (edited) I need to replace the coil packs and was wondering if any of you have done this for an Acura TL before.... Edited November 1, 2007 by addy79
douG Posted November 1, 2007 Report Posted November 1, 2007 http://cec.wustl.edu/~lrr1/coilpack/ Give this a read before you proceed, addy79. Good Luck.
wingman Posted November 1, 2007 Report Posted November 1, 2007 Hey, I used to work for honda. Why are you replacing them? are they faulty? I have never had to change them before cause they rarely go, but if you are gonna change them, there is a 10mm bolt that holds each one of them in. Unplug the connector for the coilpack and undo the bolt and they will come right out. Underneath the coil pack is a rubber sleeve that insulates the connector for the spark plug, so if it doesn't come out easy just pull up and twist it back and forth until it comes out.
addy79 Posted November 1, 2007 Author Report Posted November 1, 2007 sounds easy enough... 3 of my cylinders are misfiring (2,3,5) I've already done a tune up and added new plugs, but the problem is still persisting. I figure the next step would be to change the actual coils. hope it works! thanks for the info wingman!
ecmilley Posted November 1, 2007 Report Posted November 1, 2007 vI don't normally see 3 coils fail at the same time, with this engine make sure the egr passages are not plugged up and over didtributing exhaust gasses to 2,3,5
addy79 Posted November 1, 2007 Author Report Posted November 1, 2007 i'll take a look at it, i guess i'll be able to tell by the sparkplugs and the amount of carbon buildup on em
ecmilley Posted November 1, 2007 Report Posted November 1, 2007 one other thing is there could be one bad coil causing misfire codes on all 3 before pulling plugs and such, do a cylinder balance test( easiest way would be unhook idle motor with engine running and disconnect coil connecter from each coil and note rpm drop from each cylinder. ie rpm at idle 800 rpm unhook cyl#1 should drop at least 75 rpm, hooked it back up disconnect cyl#2 rpm drop is zero, that would be the problem cylinder
addy79 Posted November 1, 2007 Author Report Posted November 1, 2007 ahhh nice! good idea, i'll give that a try first, thanks for the tip ecmilley!!
irishfield Posted November 1, 2007 Report Posted November 1, 2007 Just don't have your knee a 1/2" back from a bare metal bumper when you do it!
Tybo Posted November 2, 2007 Report Posted November 2, 2007 I use a spark tester. It's a shocking experience to find out it's a bad wire.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now