fisherman7 Posted July 30, 2018 Report Share Posted July 30, 2018 Hi all, I have the above unit. Started acting up a few weeks ago where no matter how deep I was it'd only read between 2.6' and 3.0'. I'd shut it off, restart it and it'd work for about 10 minutes and start again. Transducer and cable are good as is power supply and voltage. I've reduced the sensitivity as per the manual and still doesn't work for more than a few minutes. Lowrance is recommending a software update and a reset. Any thoughts from my learned fishermen? Link to comment Share on other sites More sharing options...
spincast Posted July 30, 2018 Report Share Posted July 30, 2018 original transducer? They do fail over time. Know anyone where you could plug the head into their ducer? That'll at least tell you if its in the head or somewhere else. Link to comment Share on other sites More sharing options...
Dan668 Posted July 31, 2018 Report Share Posted July 31, 2018 My gen 2 just had the same symptoms, ended up being the built in transducer on my trolling motor that was faulty. So like the poster above stated, try another transducer or another unit on the same transducer to rule out the issue. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now