Parnelly Posted October 19, 2014 Report Share Posted October 19, 2014 Ok so my buddy bougth a new(to him) boat. I was out at his place today to have a look at it. It appears to be equipped with EL(Loop) style leaf springs. The springs themselves seem to be flattened and the loop is outside the mounting bracket. Meaning the loop itself isnt sitting on the bushing. The trailer is also riding really low. He had to keep the motor tipped up to drive it home as it was too close to the ground. After looking at it I noticed these issues. As well as, it seems the spring could be relocated to a lower hole on the mount creating a higher ride height. So heres my question. Can the EL(Loop) style spring be replaced with an EE(eye) type spring on both ends? I should have taken a picture of it while I was there. Any comments and suggestions are welcome. Neither of us have done any trailer work before, so any insight will be greatly appreciated. Ben. Link to comment Share on other sites More sharing options...
Sinker Posted October 19, 2014 Report Share Posted October 19, 2014 Are the springs mounted under the axle, or on top of the axle? If they are under, you can gain a couple inches of height by mounting them on top of the axle.....maybe. Pics would definitely help. S. Link to comment Share on other sites More sharing options...
Fisherman Posted October 19, 2014 Report Share Posted October 19, 2014 Number one, is the trailer actually rated to carry the weight of the boat and motor. You can replace them with EE, however you would be required to to weld in the bracket for the rear shackle, maybe not designed for that or not enough room. Need some pictures. Link to comment Share on other sites More sharing options...
Parnelly Posted October 19, 2014 Author Report Share Posted October 19, 2014 Its a 14' aluminum with a 15 evinrude on the back. While the tires are small I believe from what I have seen that it should be ok to haul the boat. It has bushings and bolts at both ends, but it looks as though when the spring flattened off the loop end is no longer on the bushing but pushed out towards the rear of the trailer. Should the loop end fit tightly around the bolt/bushing or should there be a space. Ill try to get him to send me a couple cell phone pics. Link to comment Share on other sites More sharing options...
Sinker Posted October 19, 2014 Report Share Posted October 19, 2014 Mine is the same...and has been for the last 20 yrs....i thought u just wanted more height on the trailer. S. Link to comment Share on other sites More sharing options...
Parnelly Posted October 21, 2014 Author Report Share Posted October 21, 2014 Ok here's a picture of the loop end. Should it be sticking out like that? Again, my trailer has EE style springs, and I have never seen this style before. Link to comment Share on other sites More sharing options...
Sinker Posted October 21, 2014 Report Share Posted October 21, 2014 Yeah, mine are pretty much the same. S. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now